Initial project setup

managed_components/espressif__tinyusb/hw/bsp/brtmm90x/boards/mm900evxb/board.h

@@ -0,0 +1,87 @@
+/*
+ * The MIT License (MIT)
+ *
+ * Copyright 2021 Bridgetek Pte Ltd
+ *
+ * Permission is hereby granted, free of charge, to any person obtaining a copy
+ * of this software and associated documentation files (the "Software"), to deal
+ * in the Software without restriction, including without limitation the rights
+ * to use, copy, modify, merge, publish, distribute, sublicense, and/or sell
+ * copies of the Software, and to permit persons to whom the Software is
+ * furnished to do so, subject to the following conditions:
+ *
+ * The above copyright notice and this permission notice shall be included in
+ * all copies or substantial portions of the Software.
+ *
+ * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR
+ * IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY,
+ * FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE
+ * AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER
+ * LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM,
+ * OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN
+ * THE SOFTWARE.
+ *
+ * This file is part of the TinyUSB stack.
+ */
+
+/* metadata:
+   name: MM900EVxB
+   url: https://brtchip.com/product/mm900ev1b
+*/
+
+#ifndef BOARD_H_
+#define BOARD_H_
+
+// Note: This definition file covers all MM900EV1B, MM900EV2B, MM900EV3B,
+// MM900EV-Lite boards.
+// Each of these boards has an FT900 device.
+
+#ifdef __cplusplus
+ extern "C" {
+#endif
+
+// UART to use on this board.
+#ifndef BOARD_UART
+#define BOARD_UART UART0
+#endif
+
+// UART is on connector CN1.
+#ifndef BOARD_GPIO_UART0_TX
+#define BOARD_GPIO_UART0_TX 48 // Pin 4 of CN1.
+#endif
+#ifndef BOARD_GPIO_UART0_RX
+#define BOARD_GPIO_UART0_RX 49 // Pin 6 of CN1.
+#endif
+
+// LED is connected to pins 17 (signal) and 15 (GND) of CN1.
+#ifndef BOARD_GPIO_LED
+#define BOARD_GPIO_LED 35
+#endif
+#ifndef BOARD_GPIO_LED_STATE_ON
+#define BOARD_GPIO_LED_STATE_ON 1
+#endif
+// Button is connected to pins 13 (signal) and 15 (GND) of CN1.
+#ifndef BOARD_GPIO_BUTTON
+#define BOARD_GPIO_BUTTON 56
+#endif
+// Button is pulled up and grounded for active.
+#ifndef BOARD_GPIO_BUTTON_STATE_ACTIVE
+#define BOARD_GPIO_BUTTON_STATE_ACTIVE 0
+#endif
+
+// Enable the Remote Wakeup signalling.
+// Remote wakeup is wired to pin 40 of CN1.
+#ifndef BOARD_GPIO_REMOTE_WAKEUP
+#define BOARD_GPIO_REMOTE_WAKEUP 18
+#endif
+
+// USB VBus signal is connected directly to the FT900.
+#ifndef BOARD_USBD_VBUS_DTC_PIN
+#define BOARD_USBD_VBUS_DTC_PIN 3
+#endif
+
+#ifdef __cplusplus
+ }
+#endif
+
+#endif